HIGHSIDER AKRON-RS PRO License Plate Holder incl. License Plate Light

The HIGHSIDER license plate holder AKRON-RS PRO optimally adapts to the lines of your bike due to its design.

The model-specific bracket of the AKRON-RS PRO enables mounting on the original mounting points of your bike, thus allowing an exchange without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane.

The license plate is made of steel sheet and 2 mm thick. The precise cut is done by laser. This is followed by edge finishing and a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Due to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator holder of the AKRON-RS PRO are adjustable in width and thus suitable for any kind of accessory indicators. Due to this adjustability you can adjust the position for your indicators to various license plates. To enable the mounting of the indicators without separating them from the wiring harness, the 8 mm bores are slotted to the side.

You can also individually adjust the position of the reflector via a slider. An adjustment to the different designs of EU license plates is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

In this PRO version of the AKRON-RS, the very small, milled from high-quality aluminum HIGHSIDER license plate light with mounting plate and support arm is included. The holder is adjustable in height and designed in such a way that mounting in the legally prescribed position is possible.

Details:
• model-specific bracket
• stepless adjustable indicator holder
• slotted indicator holder for easy mounting without cable separation
• stepless adjustable reflector, E-approved
• suitable for European license plates
• stepless adjustable tilt angle
• additional screw for optimal positional safety
• easy fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes
• license plate light incl. holder included in the scope of delivery
• license plate light, E-approved
• stepless adjustable license plate illumination
• many different options for attaching the license plate light

The scope of delivery of the AKRON-RS PRO includes:
• Model-specific bracket with mounting parts
• AKRON-RS license plate holder plate
• Adjustable indicator holder
• E-approved reflector with adjustable holder
• E-approved license plate light
• Mounting instructions

Notes:
• For the original indicators, a special indicator holder is optionally available in the Accessories tab.
• If lateral reflectors are mounted on your original license plate holder, these must be reattached at a suitable position or replaced by new ones.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.