HIGHSIDER AKRON-RS PRO License Plate Holder incl. License Plate Light

The HIGHSIDER AKRON-RS PRO license plate holder optimally adapts to the lines of your bike due to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS PRO enables mounting to the original attachment points of your bike, thus allowing replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of sheet steel and 2 mm thick. The precise cut is done by laser. This is followed by a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Due to the stepless adjustment possibility, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator light holders of the HIGHSIDER AKRON-RS PRO are adjustable in width and therefore suitable for any type of accessory indicators. With this adjustment possibility, you can adjust the position for your indicators to the most different license plates. To enable the mounting of the indicators without separating them from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. Adaptation to the different versions of the EU license plates is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

In this PRO version of the HIGHSIDER AKRON-RS, the very small, milled from high-quality aluminum HIGHSIDER license plate light with mounting plate and support arm is included. The holder is adjustable in height and designed in such a way that mounting in the legally prescribed position is possible.

Details:
• model-specific bracket
• steplessly adjustable indicator holders
• slotted indicator holder for easy mounting without cable separation
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable angle of inclination
• additional screw for optimal positional stability
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through oblong holes
• License plate light incl. holder included
• License plate light, E-approved
• steplessly adjustable license plate illumination
• many different options for attaching the license plate light

The scope of delivery of the HIGHSIDER AKRON-RS PRO includes:
• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate holder
• Adjustable indicator holders
• E-approved reflector with adjustable holder
• E-approved license plate light
• Mounting instructions

Wiring license plate light:
• White = Plus
• Black = Ground

Notes:
• Since the original taillight of your motorcycle is omitted when mounting this license plate holder, we offer you a suitable replacement in the Accessories tab. There you will find our modern and approved for road traffic 3in1 combinations.
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.
• For the original indicators we offer you, also in the Accessories tab, optionally a special indicator holder.

Tip:
If you have not found a vehicle-specific license plate holder for your vehicle, then you will certainly find what you are looking for with the universal license plate holders from HIGHSIDER, which are available in many different versions.