HIGHSIDER AKRON-RS PRO License Plate Holder incl. License Plate Light

The license plate holder HIGHSIDER AKRON-RS PRO optimally adapts to the lines of your bike thanks to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS PRO enables mounting to the original attachment points of your bike, thus allowing an exchange without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of sheet steel and 2 mm thick. The precise cut is done by laser. After edging, a weather-resistant, black powder coating follows.
This ensures the optimal fit and durability.
Due to the infinitely adjustable possibility, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The turn signal holders of the HIGHSIDER AKRON-RS PRO are adjustable in width and thus suitable for any type of accessory turn signals. Through this adjustment possibility, you can adjust the position for your turn signals to the different license plates. To enable the mounting of the turn signals without separating from the wiring harness, the 10 mm bores are slotted to the side.

You can also adjust the position of the reflector individually via a slider. An adjustment to the different versions of the EU license plates is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

In this PRO version of the HIGHSIDER AKRON-RS, the very small, milled from high-quality aluminum HIGHSIDER license plate light with mounting plate and support arm is included. The bracket is adjustable in height and designed in such a way that mounting in the legally prescribed position is possible.

Details:

• model-specific bracket
• infinitely adjustable turn signal holders
• slotted turn signal holder for easy mounting without cable separation
• infinitely adjustable reflector, E-approved
• suitable for European license plates
• infinitely adjustable angle of inclination
• additional screw for optimal positional stability
• easy fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes
• license plate light incl. holder included in the scope of delivery
• license plate light, E-approved
• infinitely adjustable license plate illumination
• many different options for attaching the license plate light

The scope of delivery of the HIGHSIDER AKRON-RS PRO includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate holder
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• E-approved license plate light
• Mounting instructions

Notes:
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced by new ones.
• For the original turn signals, the special turn signal holder 280-974 is optionally available.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.