HIGHSIDER AKRON-RS PRO License Plate Holder incl. License Plate Light

The license plate holder HIGHSIDER AKRON-RS PRO optimally adapts to the lines of your bike due to its design.

The model-specific holder of the HIGHSIDER AKRON-RS PRO enables mounting to the original attachment points of your bike and thus a replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.
The license plate is made of steel sheet and 2 mm thick. The precise cut is done by laser. After edging, a weather-resistant, black powder coating follows.
This ensures optimal fit and durability.
Due to the continuously adjustable possibility, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The turn signal holders of the HIGHSIDER AKRON-RS PRO are adjustable in width and thus suitable for any type of accessory turn signals. With this adjustability you can adjust the position for your turn signals to the various license plates. To enable the mounting of the turn signals without separation from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. An adaptation to the different versions of the EU license plates is therefore no problem.

To securely screw the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

In this PRO version of the HIGHSIDER AKRON-RS, the very small, milled from high-quality aluminum HIGHSIDER license plate light with mounting plate and support arm is included. The holder is adjustable in height and designed in such a way that a mounting in the legally prescribed position is possible.

Details:
• model-specific holder
• continuously adjustable turn signal holders
• slotted turn signal holder for easy mounting without cable separation
• continuously adjustable reflector, E-approved
• suitable for European license plates
• continuously adjustable tilt angle
• additional screw for optimal position safety
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes
• license plate light incl. holder included in the scope of delivery
• license plate light, E-approved
• continuously adjustable license plate illumination
• many different options for attaching the license plate light

The scope of delivery of the HIGHSIDER AKRON-RS PRO includes:
• Model-specific holder with mounting parts
• HIGHSIDER AKRON-RS license plate holder plate
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• E-approved license plate light
• Installation instructions

Notes:
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced by new ones.
• For the original turn signals, the special turn signal holder 280-972 is optionally available.

Tip:
If you haven't found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.