HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder optimally adapts to the lines of your bike thanks to its design.

The model-specific mount of the HIGHSIDER AKRON-RS allows installation on the original mounting points of your bike, thus enabling replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of steel sheet and is 2 mm thick. The precise cut is done by laser. After edging, it receives a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Due to the stepless adjustment option, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The turn signal holders of the HIGHSIDER AKRON-RS are adjustable in width and thus suitable for any type of accessory turn signals. Due to this adjustment option, you can adapt the position for your turn signals to different license plates. To enable the installation of the turn signals without disconnecting from the wiring harness, the 10 mm bores are slotted to the side.

You can also individually adjust the position of the reflector using a slider. An adaptation to the different versions of the EU license plates is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate from below.

Details:

• model-specific mount
• steplessly adjustable turn signal holders
• slotted turn signal holder for easy mounting without cable disconnection
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable angle of inclination
• additional screw for optimal positional security
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes

The scope of delivery of the HIGHSIDER AKRON-RS includes:

• Model-specific mount with mounting parts
• HIGHSIDER AKRON-RS license plate
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• Mounting instructions

Notes:
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.
• For the original turn signals, the special turn signal holder 280-975 is optionally available.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.