HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder optimally adapts to the lines of your bike thanks to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS enables mounting to the original attachment points of your bike, thus allowing replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of steel sheet and is 2 mm thick. Precise cutting is done by laser. This is followed by weather-resistant, black powder coating.
This ensures optimal fit and durability.
Thanks to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator holder of the HIGHSIDER AKRON-RS are width-adjustable and therefore suitable for any type of accessory indicators. This adjustability allows you to adapt the position for your indicators to the various license plates. To enable the mounting of the indicators without disconnecting from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. Adaptation to the different versions of the EU license plate is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

Details:

• model-specific bracket
• stepless adjustable indicator holders
• slotted indicator mount for easy installation without cable disconnection
• stepless adjustable reflector, E-approved
• suitable for European license plates
• stepless adjustable tilt angle
• additional screw for optimal positional stability
• simple fixing without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes

The scope of delivery of the HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate
• Adjustable indicator holders
• E-approved reflector with adjustable holder
• Mounting instructions

Notes:
• If there are side reflectors mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.
• For the original indicators, the special indicator holder 280-977 is optionally available.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.