HIGHSIDER AKRON-RS License Plate Holder

The license plate holder HIGHSIDER AKRON-RS optimally adapts to the lines of your bike due to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS enables mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of steel sheet and 2 mm thick. The precise cut is done by laser. This is followed by weather-resistant, black powder coating.
This ensures the optimal fit and durability.
Due to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator holder of the HIGHSIDER AKRON-RS are adjustable in width and therefore suitable for any type of accessory indicators. This adjustability allows you to adjust the position for your indicators to different license plates. To enable the installation of the indicators without separating from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. An adaptation to the different designs of the EU license plates is therefore no problem.

To securely screw the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

Details:
• model-specific bracket
• steplessly adjustable indicator holder
• slotted indicator mount for easy installation without cable separation
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable angle of inclination
• additional screw for optimal positional security
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes

The scope of delivery of the HIGHSIDER AKRON-RS includes:
• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate
• Adjustable indicator holder
• E-approved reflector with adjustable holder
• Mounting instructions

Notes:
• For the original indicators, the special indicator holder 280-984 is optionally available.
• If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.

Tips:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.