HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder optimally adapts to the lines of your bike with its design.

The model-specific bracket of the AKRON-RS allows mounting to the original mounting points of your bike, thus enabling a replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane.

The license plate is made of steel sheet and 2 mm thick. The precise cut is made by laser. This is followed by edging and a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Thanks to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator bracket holders of the AKRON-RS are adjustable in width and thus suitable for any type of accessory indicators. This adjustability allows you to adapt the position for your indicators to different license plates. To enable the mounting of the indicators without disconnecting the wiring harness, the 8 mm holes are slotted to the side.

You can also adjust the position of the rear reflector individually using a slider. Adaptation to different versions of EU license plates is therefore no problem.

To securely screw the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

Details:
• model-specific bracket
• steplessly adjustable indicator holders
• slotted indicator holder for easy mounting without cable disconnection
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable tilt angle
• additional screw for optimal positional security
• easy fixing without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes

The scope of delivery of the AKRON-RS includes:
• Model-specific bracket with mounting parts
• AKRON-RS license plate
• Adjustable indicator holders
• E-approved rear reflector with adjustable holder
• Mounting instructions

Notes:
• For the original indicators, a special indicator holder is optionally available in the Accessories tab.
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.

Tips:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.