HIGHSIDER AKRON-RS PRO License Plate Holder incl. License Plate Light

The HIGHSIDER License Plate Holder AKRON-RS PRO optimally adapts to the lines of your bike thanks to its design.

The model-specific bracket of the AKRON-RS PRO allows mounting to the original mounting points of your bike, thus enabling replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane.

The license plate is made of steel sheet and 2 mm thick. The precise cut is done by laser. This is followed by edge finishing and a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Thanks to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The turn signal holders of the AKRON-RS PRO are adjustable in width and therefore suitable for any type of accessory turn signals. This adjustability allows you to adjust the position for your turn signals to different license plates. To enable the mounting of the turn signals without disconnecting the wiring harness, the 8 mm holes are slotted to the side.

You can also adjust the position of the reflector individually using a slider. Adapting to the different versions of the EU license plate is therefore no problem.

To securely screw the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

In this PRO version of the AKRON-RS, the very small, CNC-milled from high-quality aluminum HIGHSIDER license plate light with mounting plate and support arm is included. The holder is adjustable in height and designed in such a way that mounting in the legally prescribed position is possible.

Details:
• model-specific bracket
• steplessly adjustable turn signal holders
• slotted turn signal mounting for easy mounting without cable disconnection
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable tilt angle
• additional screw for optimal positional stability
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes
• License plate light incl. holder included in the scope of delivery
• License plate light, E-approved
• steplessly adjustable license plate illumination
• many different options for attaching the license plate light

The scope of delivery of the AKRON-RS PRO includes:
• Model-specific bracket with mounting parts
• AKRON-RS license plate holder plate
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• E-approved license plate light
• Mounting instructions

Notes:
• For the original turn signals, a special turn signal holder is optionally available in the Accessories tab.
• If lateral reflectors are mounted on your original license plate holder, these must be reattached at a suitable position or replaced with new ones.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.