HIGHSIDER AKRON-RS PRO Registration Plate Holder incl. Registration Plate Light

The registration plate holder HIGHSIDER AKRON-RS PRO optimally adapts to the lines of your bike due to its design.

The model-specific holder of the HIGHSIDER AKRON-RS PRO enables mounting to the original attachment points of your bike, thus allowing replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The registration plate is made of steel sheet and 2 mm thick. The precise cut is made by laser. This is followed by edge finishing and weather-resistant, black powder coating.
This ensures optimal fit and durability.
Thanks to the stepless adjustment option, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The turn signal holders of the HIGHSIDER AKRON-RS PRO are adjustable in width and therefore suitable for any type of accessory turn signals. Thanks to this adjustment option, you can adapt the position for your turn signals to different registration plates. To enable the mounting of the turn signals without separating them from the wiring harness, the 10 mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. Adapting to the different versions of the EU registration plates is therefore no problem.

To securely screw on the registration plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the registration plate on its underside.

In this PRO version of the HIGHSIDER AKRON-RS, the very small, machined from high-quality aluminum HIGHSIDER registration plate light with mounting plate and support arm is included. The holder is adjustable in height and designed in such a way that mounting in the legally prescribed position is possible.

Details:

• model-specific holder
• steplessly adjustable turn signal holders
• slotted turn signal receptacle for easy mounting without cable separation
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable angle of inclination
• additional screw for optimal positional stability
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the registration plate through elongated holes
• registration plate light incl. holder included in the scope of delivery
• registration plate light, E-approved
• steplessly adjustable registration plate illumination
• many different options for attaching the registration plate light

The scope of delivery of the HIGHSIDER AKRON-RS PRO includes:

• Model-specific holder with mounting parts
• HIGHSIDER AKRON-RS registration plate holder plate
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• E-approved registration plate light
• Mounting instructions

Notes:
• If lateral reflectors are mounted on your original registration plate holder, these must be reattached in a suitable position or replaced with new ones.
• For the original turn signals, the special turn signal holder 280-974 is optionally available.

Tip:
If you have not found a model-specific registration plate holder for your vehicle, the universal registration plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.