HIGHSIDER AKRON-RS Targa Holder

The HIGHSIDER AKRON-RS Targa Holder optimally adapts to the lines of your bike thanks to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS enables mounting to the original fastening points of your bike, thus allowing replacement without further drilling or cutting.
To avoid damage to cables, all sharp edges are protected by a rubber membrane grommet.

The license plate is made of steel sheet and 2 mm thick. The precise cut is made by laser. This is followed by edge finishing and a weather-resistant, black powder coating.
This ensures optimal fit and durability.
Thanks to the stepless adjustability, you can bring the plate into the desired position without drilling. To hold the plate in this position, there is an additional locking screw.

The indicator holder of the HIGHSIDER AKRON-RS are adjustable in width and thus suitable for any type of accessory indicators. This adjustability allows you to adapt the position for your indicators to various license plates. To enable the mounting of the indicators without separating from the wiring harness, the 10 mm bores are slotted to the side.

You can also adjust the position of the reflector individually via a slider. An adaptation to the different versions of the EU license plates is therefore no problem.

To securely screw on the license plate and reduce vibrations, two rubber washers are included in the scope of delivery. Another rubber buffer supports the license plate on its underside.

Details:

• model-specific bracket
• steplessly adjustable indicator holder
• slotted indicator holder for easy mounting without cable separation
• steplessly adjustable reflector, E-approved
• suitable for European license plates
• steplessly adjustable tilt angle
• additional screw for optimal positional stability
• simple fixation without further work steps (e.g. drilling)
• easy mounting of the license plate through elongated holes

The scope of delivery of the HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate holder
• Adjustable indicator holder
• E-approved reflector with adjustable holder
• Mounting instructions

Notes:
• If lateral reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.
• For the original indicators, the special indicator holder 280-975 is optionally available.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.